Factory recommended oil levels and info on type and appearance in use.
Factory recommend annual maintanence required to keep your Turbosteer like new, year after year
Factory recommended lubrication intervals and methods for the Turbomsteer hitch
Info on the proven Turbomist reduction drive system, purpose and advantages
Turbomist pressure gauge information
Center location on 2010 forward models, and the different types of baskets available on different series of sprayers
Information on pressure adjustments of the IP regulator, the standard red handled regulator used by Turbomist for over twenty years.
Factory recommended greasing procedure for the Rears style hitch by Turbomist
Video shows which nipples require daily and which require only yearly greasing , and how much grease is required
Recommended timing and quantiy of grease required by your Turbomist PTO
Video shows daily and yearly greasing required on the hi drive 150 series turbomist sprayers.
Recommend greasing of turbomist wheel bearings, how to and how offer
Factory recommend greasing procedure for the Turbosteer turning hitch by Turbomist
This video outlines the position of the handle in each of the three gearbox positions.
Video shows how you can either flush clean the filter or remove it if necessary. These filters are used to stop plugging of small nozzles that allow excellent micron drop size and coveage.
Explaining the switches on a diaphragm model with teejet ss electric ball valve controls, including the importance of correctly wiring the unit to the tractor.
This control box on a centrifugal pump model, has in addition to pressure adjust toggle, a mixing basket toggle switch which allows the operator to put all the pump volume to use mixing.
We recommend you check this bearing, which is part of the belt tensioner on all turbomist airblast sprayers, every time you grease the packing gland, which should be daily
Daily greasing is required on the agitation system, watch and note where and how much
Pay attention to the distance from the cross on the tractor to the pin and the cross on the sprayer to the pin, they should be as close to equal as you can arrange, either by adjusting the tractor drawbar or the sprayer hitch tube lenght,
Smaller rather than larger is better when choosing a draw bar pin, what you do not want is a pin that just fits the hole and binds when the tractor or sprayer enter a hole, valley or low spot in your block
Changing axle positions on a turbomist sprayer,allowing you to level the sprayer
Turbomist design their booms to allow easy cleanout of build up regardless of what chemicals you use.
This video explains how a offset reducton drive protects your pump and how to properly adjust your chain tension